The last e mail from him was where he asked me to send him my ini files, which I did. Anyway, I have been trying to reach him for 2 weeks, and nothing.
A year ago he came on remote cause my PM software was acting strange and he, by going right onto the PC, found some errors and re structured things. I thought you were still active with PM and Enrico. Of course, I have it set for the PM MCP software to recognize the CPflight MCP hardware, and which ever one I turn dials or buttons on, it will show on the PM GC displays. When I show the PM MCP window, and either work the buttons on it or turn the CPflight MCP hardware buttons and dials, it shows up on the PM MCP. The Project M's MCP software is controlling the CPflight MCP hardware and of course, the PM GC displays. I did check out this PMDG 737 site and prob will buy their plane, if everyone is using it. So what is layman's terms do you think is the problem and what should I try next. I think even he was unsure just what to do?
When Enrico went into my sim PC thru Teamviewer about a few weeks ago, I asked him to check out this problem and he went into FSUIPC to buttons, then went to the lists on the right for push and release and scrolled down to the PM items and clicked PM MCP off or master (one of those) but nothing happened after he had hung up. Like I had said before Project M's MCP software, I could go into FSUIPC or P3D controls/buttons thru my Leo Badnar board and set AT or AP disconnect OK. Its just when I go into FSUIPC to buttons, and try to program AP or AT disconnect, I am not sure just what or where to go. And when you make adjustments with the CPflight MCP unit, it shows up in the Project M's GC displays. There is in the Project M's MCP ini file even a line that you put on or yes to that your using a CPflight unit with its com port #. When Project M's MCP boots up in the background, the CPflight's MCP hardware comes on automatically next. Your right, I am using the Project Magenta's 737-800 from their site for now.Īs of right now, my CPflight MCP 2004 MCP hardware unit DOES work with Project M's MCP software and or just with the Project M's 737-800. Pete, thanks for the info, but now I am more confused than ever. This is the crucial statement:in your message: The "AP DISCONNECT" is a larger lever-type switch below. However, the A/P on and A/P off controls should only operate the AP button on the MCP.
Which will work directly with the PM 737 I think because as far as I can recall the latter is basically the default FS aircraft with all the same controls exactly. Your FSUIPC INI file only contains 2 button assignments:
If you do really mean you are using Project Magenta software with their aircraft and their MCP, then everything should work fine if you keep to PM. Best if you are more specific, saying "Project Magenta". The PMDG 737NGX is the most popularly used 737 model around so I thought that was what you meant. When you say "PM 737" do you mean Project Magenta? They have a 737-800? If so, my mistake. What does PMDG stand for? Is it Project M or some other airplane software?Īh, sorry.